Orland Park grew in waves, and each wave left a different roofline. Old Orland, along 143rd and Beacon, has frame houses from the early 1900s. The streets between 143rd and 159th filled in through the 1970s and 80s with split-levels, bi-levels, and ranches. And the areas around Silo Ridge, Crystal Tree, and south toward 179th are big brick two-stories from the 90s and 2000s. Christmas light installation in Orland Park, IL is mostly a question of which roofline you own — because the roofline is the display.
We install across the southwest suburbs every November, and Orland Park is where we see the widest range of house shapes in one town. Here's the honest guide.
The split-level and bi-level: connect the two lines
The single most common house we light in Orland Park is a split-level or bi-level — the two-roofline layout that dominated the 70s and 80s. It's also the one most often lit wrong.
The problem: two eaves at different heights that don't meet. Light both and you get two floating bars. Light one and the house looks unfinished.
The fix we use on every Orland Park split: run the upper eave, bring a vertical line down the joint where the tall section meets the low one, and continue along the lower eave. The two bars become one stepped outline — which is the house's actual shape. It's a small detail that turns a confusing display into a clean one.
Bi-levels have an extra wrinkle: the front door is often half a flight up, under a small overhang. Lighting that overhang's edge makes the entry visible from the street at night. Without it, the door vanishes.
The ranch: one line, done well
Orland Park's ranches — many of them brick-front, some with attached garages that project forward — are the easiest house to light and the easiest to over-light.
One warm white C9 run along the front eave, corner to corner, with clips every 12 inches so the line stays straight. If the garage projects, frame the garage door too. Then one accent: a wrapped front-yard tree or a single lit ornamental. That's the whole display. Adding shrub nets and walkway stakes pulls the eye below the roofline and makes a one-story house look shorter.
The 90s–2000s two-story: light every street-facing gable
Around Silo Ridge, Crystal Tree, Centennial Park, and the subdivisions south of 159th, the houses are brick two-stories with two, three, or four front-facing gables and a front-load garage.
Rule: light every gable that faces the street, or none. Three lit and one dark reads as a failure. Full front eave, all front gables outlined to a clean point at each peak, garage door frame, and the entry marked. On the larger lots, a wrapped front tree ties it to the street. Our Orland Park installation crews handle this configuration weekly.
The brick in these neighborhoods runs to darker browns and reds, which push warm white warmer — a free advantage. Standard warm white looks rich here.
Old Orland: scale down
The historic frame homes along 143rd and the surrounding blocks are small-scale, close to the street, and full of porch detail. C9 bulbs overwhelm them. We use C7 or smaller, follow the porch roof and the main gable, and add wrapped porch columns or lit garland on the railing. A single wrapped tree if the lot has one. The look is quieter than a Silo Ridge two-story and it should be.
Aluminum siding and the color question
A lot of Orland Park's 70s and 80s housing has aluminum or vinyl siding in white, cream, or pale grey. Pale siding reflects strongly, so a display looks bright with fewer bulbs — but it also shows every uneven gap and sag in the line. Straight, evenly clipped runs matter more on siding than on brick. This is one reason DIY displays on sided houses often look worse than the same lights on a brick neighbor's home.
Pale grey siding also pulls warm white toward neutral; we spec the warmer end so it reads golden. Full breakdown in how warm white behaves on each exterior.
Timing for Orland Park
Orland Park is a big town with a lot of houses that fit our standard design, which makes it efficient for us — and popular. November slots fill from early October. Cook County's first freeze usually arrives in the last week of October, after which steep gables get slower and ladder footings ice up.
Request a free holiday lighting quote in September to choose your week. Tinley Park, Palos Park, Homer Glen, and Mokena book on the same schedule.
FAQ
How do you hang Christmas lights on a split-level house?
Run the upper eave, drop a vertical line down the joint between the tall and low sections, and continue along the lower eave so the two rooflines read as one stepped outline. Mark the entry overhang so the door is visible.
How much does professional Christmas light installation cost in Orland Park?
Ranches and split-levels sit in the lower-to-middle range because the front rooflines are short and ladder-reachable. Multi-gable two-stories cost more. Every price includes design, commercial-grade LED product, installation, full-season maintenance, late-January-or-February takedown, and storage.
Do the lights hurt my gutters or siding?
No. We use clips designed for shingles and gutters — no nails, staples, or adhesive — and they come off cleanly at takedown.
What part of Orland Park do you serve?
All of it. Orland Park is inside our 25-mile radius from Darien, along with Orland Hills, Palos Park, Palos Heights, Tinley Park, and Homer Glen.
Book your Orland Park installation
Split-level, ranch, two-story, or Old Orland frame — the display follows your roofline. Twinkle Bros Lighting LLC designs it, supplies commercial-grade LED, installs, maintains all season, removes in late January or February, and stores it, fully insured. Request a free holiday lighting quote or call (708) 316-GLOW while October dates remain.